Xantrex 400 Manual do Utilizador descarregar pdf (Página 29)

Boosting a Vehicle’s Engine

To operate a 12 V DC appliance:

1. Open the protective cover on the DC Power Outlet of the

XPower Powerpack.

2. Plug the 12 V DC appliance into the DC Power Outlet on

the left side of the unit, and turn the 12 V DC appliance

on (if required).

If the 12 V DC appliance draws more than 12 A (or has a

short-circuit defect), the internal circuit breaker of the

XPower Powerpack shuts off the power to the 12 V DC

appliance. If this occurs, unplug the 12 V DC appliance,

and the internal circuit breaker automatically resets after

a few seconds.

3. Fully recharge the XPower Powerpack as soon as

possible after each use.

As the DC Power Outlet is internally wired directly to the

XPower Powerpack’s battery, extended operation of a

12 V DC appliance may result in excessive battery

discharge. See Caution for Equipment damage on

page 16.

Boosting a Vehicle’s Engine

You can use the XPower Powerpack to boost a vehicle or

boat engine (all 4 cylinder and most 6 cylinder engines) that

has a 12 V starting battery using the supplied boost cables.

WARNING: Fire hazard

Never allow boosting cables’ red and black clamps to touch each

other or another common metal conductor. This could cause

damage to the unit and/or create a sparking/explosion hazard.

Always switch OFF the Boosting Power Switch and store boosting

clamps in the appropriate holder on each side of the XPower

Powerpack after use.

XPower_PP_200_Plus.book Page 17 Monday, October 23, 2006 2:57 PM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

Sem comentários

Xantrex 400 Manual do Utilizador Página 29