Xantrex MS2000 Manual do Utilizador Página 101
- Página / 126
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Specifications
975-0125-02-01 A–3
Main Charger Specifications
All charging specifications are at nominal conditions: ambient temperature of 77
°F (25 °C), 120 VAC, 60 Hz input, unless otherwise specified.
Table A-2
Main Charger Specifications
Charging method • Three-stage charge (Bulk, Absorption, Float)
• Two-stage charge (Bulk, Absorption)
The default charging method is three-stage.
Without a battery temperature
sensor
Three settings with the following temperature
values:
• Cool 50 °F (10 °C)
• Warm 77 °F (25 °C)
• Hot 104 °F (40 °C)
The default value for this setting is Hot, and it can
only be changed by a dealer, factory, or service
center.
With a battery temperature
sensor
The temperature compensation coefficients on a
12 volt battery are as follows:
• Flooded: 27 mV × (25 °C – BTS °C)
• Gel: 27 mV × (25 °C – BTS °C)
• AGM: 21 mV × (25 °C – BTS °C)
Equalization cycle Yes, manual via System Control Panel
Number of independent battery
banks
1
Battery bank size settings 50 – 2000 Ah
Battery type settings Flooded, AGM, Gel, Custom
Power factor corrected charging Yes
AC input voltage 90 – 135 VAC
AC input frequency 60 Hz nominal, 55 – 65 Hz operating range
Minimum battery voltage 3.0 VDC
Maximum DC output voltage 16.0 VDC
Charger efficiency ≥ 85%
Input power factor at full
charge rate
> 0.95
Maximum charge current 100 A
- Operation Guide 1
- About This Guide 5
- Conventions Used 6
- Symbols Used 6
- Related Information 7
- Contact Information 7
- Important Safety Instructions 9
- Explosive Gas Precautions 11
- FCC Information to the User 12
- Contents 13
- Configuration 14
- Troubleshooting 15
- 975-0125-02-01 xv 17
- Introduction 19
- Premium Power and Ease of Use 20
- How MS2000 Works 21
- 1–4 975-0125-02-01 22
- Xanbus System 23
- Xanbus Enabled 23
- MS2000 Features 25
- Figure 1-3 26
- Table 1-2 26
- Side Panel Features 27
- CAUTION: Equipment Damage 27
- Figure 1-5 28
- DC Grounding Completed 28
- DC Terminal Covers 29
- Battery Temperature Sensor 29
- Operation 31
- Important: 32
- On Start Up 34
- Power On Reset 34
- System Start-up Check 35
- System Modes 36
- Operate Mode 37
- Power Save Mode 37
- Safe Mode 38
- CAUTION: Unexpected behavior 38
- 975-0125-02-01 2–9 39
- Hibernate mode 40
- 975-0125-02-01 2–11 41
- Operating in Invert Mode 42
- Power Output 43
- Operating in Charger Mode 44
- Echo Charger Operation 45
- 2–16 975-0125-02-01 46
- WARNING: Explosive gases 48
- Equalizing Batteries 49
- Power Share 52
- Faults and Warnings 54
- System Control 56
- System Menu Map 57
- Viewing the System Screen 58
- 975-0125-02-01 3–5 59
- MS2000 Configuration Menus 60
- 975-0125-02-01 3–7 61
- MS2000 Device Menu 62
- AC Input 63
- Echo Chg Out 63
- MS2000 Menu (Basic) 64
- Equalize 66
- 975-0125-02-01 3–13 67
- 3–14 975-0125-02-01 68
- Batt Type 69
- Batt Size 69
- Clear Faults 70
- MS2000 Menu (Advanced) 71
- Max Chg Rate 72
- Echo Chg 72
- Load Sense 73
- View Device Info 73
- Basic Menu 73
- 975-0125-02-01 3–21 75
- Sub-Menus 76
- Sense Interval 77
- # Chg Stages 77
- Eqz Volts 78
- Force Charge 78
- Lo AC Volt 79
- Lo AC Freq 79
- Hi AC Volt 80
- Hi AC Freq 80
- View Fault Log 81
- View Warning Log 81
- View Event Log 81
- Restore Defaults 82
- Warning Types 85
- Troubleshooting Reference 86
- 975-0125-02-01 4–5 87
- Warning Messages 88
- Table 4-3 89
- Fault Messages 91
- Table 4-4 92
- Inverter Applications 97
- Searching 98
- Specifications 99
- Inverter Specifications 100
- Main Charger Specifications 101
- Echo Charger Specifications 102
- Environmental Specifications 103
- Regulatory Approvals 103
- Fan Operation 103
- Charger Mode 104
- Reference for the Main 105
- Battery Charging 105
- Charge Algorithm Stages 106
- Bulk Charge 107
- Absorption Charge 107
- Float Charge 107
- Two-Stage Charging 108
- Charge Algorithm Graph 109
- Charge Algorithm Definitions 109
- AC Reconnect Summary 110
- Terminology 111
- Glossary 112
- Abbreviations 115
- Warranty 117
- Disclaimer 118
- Return Procedure 119
- Out of Warranty Service 119
- Information About Your System 120
- Xantrex Technology Inc 126
Manuais e produtos relacionados com Adaptadores e conversores de corrente Xantrex MS2000
(26 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais